APEC Water Systems RO-PERM Manuel d'instructions télécharger pdf (Page 19)

Ball Valve

(Recommended)

Tee tting for

icemaker

7. Point Y Tank’s input & output connection:

Prepare tank: See Fig.12. Apply 6-8 wraps of Teflon tape to tank’s threaded Output stem on top of

tank (remove rubber cap if there is one). Screw tank Valve onto Output stem.

Tubing color: Yellow tubing. Connect the YELLOW tubing from Stage-5 T-fitting to the tank’s valve.

Fitting type: Quick-Connect fitting on ball valve. Simply push Yellow tubing into valve port.

Air pressure: The 4 gallon tank comes pre charged at 5 psi, 14 gallon tank at 7 psi.

Fig. 12

OFF Position ON Position

Tank Ball Valve

Option: Ice-maker Connection

If you want to connect product water from the RO to your ice-maker, you will need:

• One T-fitting, preferably the quick-connect type fitting

• Extra ¼ “ tubing long enough to go from the RO system to your ice-maker

• Optional: One shut-off valve, preferably the quick-connect type.

See Fig.13. Before connecting the product water line from Point Z to H, add a T-fitting near

point H to divert product water to both the ice-maker and the faucet. It is best open the line to

the ice maker after the first tank has been discarded and the 2nd tank has completely filled.

Standard 4-gallon Tank Diagram:

Refrigerator

Fig. 13

1 2 ... 14 15 16 17 18 19 20

Pas de commentaire

APEC Water Systems RO-PERM Manuel d'instructions Page 19