APEC Water Systems ROES-50 Manuel d'instructions télécharger pdf (Page 15)

2. Quick-Connect (QC) fitting (no insert, sleeve, or nut)

Fig. 10A Fig. 10B

Step 5: Positioning The System

1. Main System: The main system can stand in the sink cabinet. No need to mount the system to the

wall. If you prefer to mount the system to the wall, please make sure it can be taken down easily for

filter replacement.

2. Tank: The storage tank can lay on its side if needed. The tank works fine in this position. If the tank

cannot fit under the kitchen sink, it can be placed elsewhere up to 20 feet away from the RO system

without much pressure loss.

Step 6: Connecting The System

Fitting Types: There are 2 types of fittings provided for connecting the system

1. Metal compression nut fitting (comes with 1 insert, 1 sleeve, 1 nut)

Important! Use plastic sleeve on the plastic

tubing we provide. Do Not use metal sleeve on

plastic tubing or the connection will leak!

Fig. 10

How to connect: - See Fig. 10. Slide the compression nut onto the tubing.

- Slide the plastic sleeve onto the tubing.

- Insert the “insert” into the tubing.

- Insert the tubing into the opening of the fitting.

- Slide the brass nut up, then tighten nut with a wrench. No Teflon tape!

(An extra metal sleeve is provided in case you need to connect your own metal tubing.

Use Teflon tape if connecting metal tubing.)

1 2 ... 10 11 12 13 14 15 16 17 18 19 20

Pas de commentaire

APEC Water Systems ROES-50 Manuel d'instructions Page 15